Assembling Your Rocket Models

This page will tell you have to assemble your rocket model.

What you will need

 * Micro Rocket die-cut (from kit)
 * Sticky putty (from kit)
 * Elastic bands (from kit)
 * Launch (from kit)

Step-by-step Guide

 * 1) Make sure you have all the pieces for your rocket.
 * 2) Gently push the solid rocket through the central slot of the matching piece. Push it in at an angle and be careful not to bend either park of the rocket (as this could affter the launch.)
 * 3) Add sticky putty to the nose end of your rocket. Do not cover the groove at the nose, as this will be used for launching.
 * 4) Micro rockets should be launched with the special launcher that can be found in your kit.

Using the launcher
Before you use the launcher you need to prepare it. Feed the rubber band into the groove at the end of the launcher and pin in the centre. Connect the rubber band to the groove at the end of your rocket or aeroplane. It is now ready for you to use and to launch them into the sky. (Some launchers that you get in your kit maybe only used with certain models of planes and rockets. But be aware, they don't work on all models.)